FDM vs. SLA vs. SLS: Strength, Anisotropy & Accuracy in 3D-Printed Parts
By Neil Harwani • 1 min read • Published 13 Nov 2026
Additive manufacturing avoids mould tooling, so it often wins for low volumes, fast iteration or complex internal geometry; injection moulding wins once tooling is spread over large runs.
Student lens
Three common processes
| Process | How it works | Strengths | Watch out for |
|---|---|---|---|
| FDM | Extrudes molten filament | Cheap, fast prototypes | Weak between layers |
| SLA | Cures liquid resin with light | Fine detail, smooth finish | Brittle resins, post-curing |
| SLS | Sinters powder with a laser | Strong, no supports needed | Grainy surface, costly machines |
Anisotropy
Printed parts are usually weaker across layers than along them. Orient the part so the main load runs along the layers.
Topology optimisation
Software removes material that carries little load, producing organic lattice shapes that are light and stiff — often only manufacturable by printing.
Young-pro lens
The break-even model
For a production run of $n$ parts:
where $T$ is tooling cost and $c_m < c_p$ are unit costs. Break-even is at $n^* = T / (c_p - c_m)$. Below $n^*$, print; above it, mould.
What the simple model misses
- Lead time: no tooling wait can be worth more than unit cost for launches and spares.
- Design changes: each mould change costs money; a print file change costs almost nothing.
- Inventory: printing spares on demand can replace warehoused stock.
- Part consolidation: one printed part may replace an assembly.
Use your own supplier quotes for $T$, $c_m$ and $c_p$ — they vary a lot by material, size and region.